Pause Signal

Modified on Mon, 14 Feb, 2022 at 10:44 AM

This page provides an overview of how to use the Pause signal of the Banner Safety Controller.


Contents


Pause Signal


Using the Banner Safety Controller it is possible to enable a Pause signal from outside inputs. This action will function identically to a user hitting the selector knob during a task, which will stop the robot, then toggling run continue.


Requirements


Banner Retrofit Kit and the new Banner configuration must be installed to use this functionality.

For more information on the Banner Retrofit Kit, click here.


Instruction


To accomplish this follow the steps outlined:


1. Using the Figure below wire a signal to the Banner on the Re-enable Robot Port and the Continue Task Port.

2. To Pause a task set the Re-Enable Robot Signal to high. Once it is set high, it can then be set low.

3. To continue the task, set the Continue Task signal high. Once it is set high, it can then be set low


Banner Wiring Picture NonSafety.PNG


This Figure is shown in Appendix F of the Intera 5.1 User Guide, in the 'Sawyer Safety Overview' PDF included in the 5.1 download

 

 


Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article